Are you trying to use an obj file in CCS 6 CMD but not sure where to start? Don't worry, I got you covered. Here are the steps to get you going.

Step 1: Open the CCS 6 CMD

First, open the CCS 6 CMD on your computer. You can usually find it in the start menu or by searching for it in the search bar.

Step 2: Navigate to the directory

Use the 'cd' command to navigate to the directory where your obj file is located. For example, if your obj file is in the 'Documents' folder, you would type 'cd Documents' and press Enter.

Step 3: Linking the obj file

Next, use the 'ln' command to link the obj file with the CCS 6 CMD. Type 'ln filename.obj' and press Enter. Replace 'filename.obj' with the actual name of your obj file.

Step 4: Debugging and running

Once the obj file is linked, you can start debugging and running your program in CCS 6 CMD. Use the appropriate commands for your program, such as 'run', 'start', or 'debug', depending on your specific needs.

And that's it! You've successfully used an obj file in CCS 6 CMD. Remember that these steps might vary slightly depending on your specific setup, but this should give you a good starting point. Happy programming!